Regresar

Degradation of the resin-dentin bonds after simulated and inhibited cariogenic challenge in an in situ model

Abstract:

The aim of this study was to evaluate the resin-dentin bonds of two simplified etch-and-rinse adhesive after simulated cariogenic and inhibited cariogenic challenge in situ. Dental cavities (4 mm wide, 4 mm long, and 1.5 mm deep) were prepared in 60 bovine teeth with enamel margins. Restorations were bonded with either adhesive Adper Single Bond 2 (3MESPE) or Optibond Solo Plus (Kerr). Forty restorations were included in an intra-oral palatal appliance that was used for 10 adult volunteers while the remaining 20 dental blocks were not submitted to any cariogenic challenge [NC group] and tested immediately. For the simulated cariogenic challenge [C+DA], each volunteer dropped 20% sucrose solution onto all blocks four times a day during 14 days and distilled water twice a day. In the inhibited cariogenic challenge group [C + FA], the same procedure was done, but slurry of fluoride dentifrice (1.100 ppm) was applied instead of water. The restored bovine blocks were sectioned to obtain a slice for cross-sectional Vickers microhardness evaluation and resin-dentin bonded sticks (0.8 mm 2) for resin-dentin microtensile evaluation. Data were evaluated by two-way ANOVA and Tukey's tests (α = 0.05). Statistically lower microhardness values and degradation of the resin-dentin bonds were only found in the C + DW group for both adhesives. The in situ model seems to be a suitable short-term methodology to investigate the degradation of the resin-dentin bonds under a more realistic condition. © 2012 Wiley Periodicals, Inc.