Regresar

Evaluation of Machining Parameters in Turning Al7075-T6 Aluminum Alloy Using Dry, Flooded, and Cryogenic Cutting Fluid Conditions

Abstract:

Production industries create high-quality products through effective machining precision, lead times, productivity, cost benefits, and implementing sustainable manufacturing practices. This study compares the effect of cryogenic CO<inf>2</inf> as a cutting fluid with a flooded conventional system and dry turning on the surface roughness, early-stage tool phenomena (including adhesion, material transfer, and built-up edge (BUE) formation), and the chip morphology of aluminum 7075-T6. Taguchi’s L9 orthogonal array is applied to identify the optimal cutting parameters that minimize surface roughness (Ra). Cutting speed (Vc), feed rate (f), depth of cut (ap), and the type of cutting fluid condition were defined at three levels. The surface roughness (Ra) was determined, and the built-up edge (BUE) and chip morphology were evaluated. Moreover, SEM and energy-dispersive X-ray spectroscopy (EDX) were employed to characterize the machined surface and the cutting tools. The optimal values for the cryogenic cooling and cutting parameters are as follows: 220 m/min (Vc), 0.05 mm/rev (f), and 0.5 mm (ap). These conditions yield a surface roughness mean (Ra) of 0.736 µm, improving the surface roughness by 10.57% compared with the lowest Ra value from all of the tests. In addition, ANOVA showed the feed rate to be the most significant cutting parameter over surface roughness under the given conditions. Regarding chip morphology, snarled chip shapes are associated with low surface roughness values. The results indicate that cryogenic cutting fluid enhances the machined surface quality and reduces the built-up edge compared with dry and flooded conditions.