Regresar

A study of manganese-silicoaluminophosphate molecular sieves

Abstract:

Surface and chemical characterization were performed on a manganese- substituted silicoaluminophosphate molecular sieve (MnAPSO-11), and on a manganese-supported silicoaluminophosphate molecular sieve (Mn/SAPO-11). For comparison purposes, the characterization process was also carried out over the parent SAPO-11 molecular sieve. Different characterization techniques were used: XPS, redox cycles, 31P MAS NMR, and acidity measurements. The transformations of n-butane were carded out over the corresponding platinum promoted solids (Pt/MnAPSO-11, Pt/Mn/SAPO-11 and Pt/SAPO-11). Platinum dispersion was measured by H2 chemisorption. XPS results indicated that manganese was better dispersed on the MnAPSO-11 solid than on the supported Mn/SAPO-11 catalyst. Redox cycles showed a strong difference between the H2 (or O2) consumed by each solid. The Mn/SAPO-11 consumed nearly three times as much H2 (or O2) per Mn atom as the MnAPSO-11 solid. 31P MAS NMR results showed an increase in the intensity of the side bands, probably due to an anisotropic paramagnetic shift caused by a stronger dipolar interaction between the 31P and the paramagnetic Mn(II) ions on the MnAPSO-11 sample, when compared with the Mn/SAPO-11 solid. These results suggest a better dispersion of the manganese species on the MnAPSO-11 solid, which would facilitate the above mentioned 31P-Mn(II) interaction, in agreement with the XPS results. Acidity was measured by pyridine chemisorption at different temperatures. A larger number of (moderate + strong) Bronsted acid sites was found for the MnAPSO-11 solid compared with the SAPO-11 and Mn/SAPO-11 samples. The addition of platinum decreased the acidity. The Pt dispersions were 83%, 68% and 54% for the Pt/SAPO-11, Pt/Mn/SAPO-11 and Pt/MnAPSO-11 solids, respectively. The catalytic results indicate higher yields for the production of isobutane and isobutene over the Pt/MnAPSO-11. A severe decrease in the yield of formation of hydrocarbons with less than four carbon atoms (undesirable side reaction) was also observed for the Pt/MnAPSO-11 system compared with the Pt/SAPO-11 and Pt/Mn/SAPO-11 systems. An ensemble effect is suggested as responsible for the differences observed in the yield of formation of hydrocarbons with less than four carbon atoms. The higher yield and selectivity observed for the formation of isobutane (iso-C4) and isobutene (iso-C4=) hydrocarbons over the Pt/MnAPSO-11 solid, was accounted for in terms of the largest number of (moderate + strong) Bronsted acid sites found on this solid. The catalytic and characterization results suggest the incorporation of manganese into the molecular sieve structure for the substituted MnAPSO-11 solid.