Regresar

Highly Stable PUFs Based on Stacked Voltage Divider for Near-Zero BER Native Sensitivity to Voltage Variations

Abstract:

This paper explores a class of highly stable static monostable physically unclonable functions (PUFs) based on stacked sub-threshold voltage dividers between two nominally identical sub-circuits as bitcell core block. More specifically, compared to our previous works where two-transistor (2T) and four-transistor (4T) voltage divider based PUFs were presented and analyzed, here we propose two novel topological variants based on six-transistor (6T) and eight-transistor (8T) solutions which arise from adopting a proper reverse gate-biasing strategy within the stack with the aim of improving the resilience to on-chip noise and voltage variations, while keeping the area overhead low. These novel solutions, along with those already proposed, were tested in 180-nm CMOS technology. Raw measurements show a nominal (at 1.8 V and 25°C) bit error rate (BER) of 0.15% and 0.08% for the 6T- and 8T-based solutions, respectively, along with a BER variation of 0.016% and 0.002% per 0.1 V. With the implementation of a simple masking technique based on measurements at low supply voltage (V<inf>DD</inf> =0.3 V at 25 °C) along with a temporal majority voting (TMV) scheme, a BER of 0.006% and lower than 9.77× 10-5%, which is the minimum observable BER for the adopted statistical set, was observed for the 6T-, and 8T-core based implementations, respectively, with a corresponding masking ratio of 8.71% and 7.59%. This is achieved with an area per bit of 5,174F2 (6T solution) and 6,994F2 (8T solution).